- EX-503 clip-on electret microphone
- EX- 413 handheld microphone
For the microphone system to function, you need to set up both the recei=
ver and the transmitter. Here are the steps you need to follow (for qui=
ck set-up, simply look at step 3 on both the rec=
eiver and transmitter instructions):
WR-PRO Receiver Set-Up
- Loading the battery - if the battery compartment =
does not close properly, take out the 9 volt battery and turn it around. Th=
e negative and positive side of the battery should face in the inside of th=
e pack. The microphone system works continuously for 10 hours using one set=
of batteries. If the sound quality is poor, the batteries should be change=
d.
- Power/Frequency selector switch - when you are no=
t using the microphone system, make sure the switch is in the position OFF;=
moving it to F1 or F2 will turn the receiver on, indicated by the fact tha=
t the LED is on.
- Signal Indicator - if the receiver is on (either =
on F1 or F2) but the transmitter is off, the LED turns RED, indicating that=
the receiver battery is good. The receiver LED turns GREE=
N when you switch the frequency selector of both the receiver and transmitter on thesame frequency (it can be either F1 or F2, depending on=
the quality of the sound you hear).
- Shoe mount - this can be used for mounting the re=
ceiver to a video camera, in case you are using the microphone system to am=
plify the sound you want to record on your camera.
- Output plug - the output plug should only be used=
when you want to record the sound with a camera, in which case the plug fr=
om the receiver should be connected to the camera's "Ext.mic" jack.
- Telescopic Antenna - extend the receiver antenna =
fully in order to attain best reception.
- Earphone Jack - for monitoring the amplified soun=
d, plug the supplied earphone into the receiver's "EAR" jack; when recordin=
g the sound with a camera, you can plug the earphone into the camera's earp=
hone jack if it has one.
WR-PRO Transmitter Set-Up
- Loading the battery - same as for receiver.
- Microphone selection - plug either the EX-503 (la=
pel mic) or EX-413 (handheld mic) into the transmitter "MIC" jack and exten=
d the cord as much as possible for best transmission.
- Power/Frequency switch - turn the transmitter swi=
tch to the same frequency as the one of the receiver; if the reception is n=
oisy on F1, switch to F2 and always remember to have both the =
transmitter and receiver operating on the same frequency.
- Mounting - you can attach the transmitter to a be=
lt using the provided clip.
=
li>
Further Assistance
For further assistance using the Azden Wireless Microphone, please visit=
the Digital Media Commons