1.  BINDING GUIDELINES FOR PAPERBACKS

1.1  General guidelines

 

Most paperbound books are sent to be shelved “as-is.”  As with hardback books, barcodes are affixed to the inside back cover and the temporary location is “Inprocess” unless they are to be pam-bound (see below).  These paperbound books may need binding in the future if they show wear and tear after circulation, but many of them will hold up well for many years with limited circulation.

1.2  Guidelines for commercial binding

 

Some paperback books should be sent to the commercial bindery.  Guidelines for types of paperbacks to be commercially bound are as follows:

a pocket or needing a pocket

Rapidly superseded paperbacks.  Computer manuals that are rapidly superseded are not commercially bound.  Other titles that are rapidly superseded (e.g., annual or bi-annual editions) should not be commercially bound.  For non-document materials, anything thinner than ¼” should be sent to In-House Binding for a pamphlet binding.  Documents thinner than ¼” can be pamphlet bound on request.  Barcodes should not be attached directly to the piece, but paper clipped to the piece.  Piggyback barcodes may also be used.

Barcodes.  Paperbacks to be commercially bound should have only automatic (Sirsi supplied) barcodes and should have a temporary location of “Inprocess.”  Place them on the designated shelf in the Preservation Services area.  Preservation Services personnel will place special “piggyback” barcodes in these volumes, overlay the automatic barcode, charge them out, and send them to the bindery.  Do not put barcodes in any books going to the bindery unless you use “piggy-back” barcodes.

Rush books.  Rush books that need to go to the commercial bindery should receive a regular barcode in the back, with a note penciled above to “send to Binding when discharged,” then given to the Marking Table.

Flags.  Do not put any flags (Reference, Restricted, Cut pages, BIC, WRC) for items going to commercial binding.  Do use “Notify” and “Book Plate” flags.  Remember that if the record number is written too close to the bottom of the title page it may be trimmed off.  Books needing “Tip-in” book plates can be sent to the bindery with a flag noting that it needs a “Tip-in.”

Questions.  When in doubt, consult the Preservation Librarian

2.  BINDING GUIDELINES FOR SETS

 

Sets should be bound to match, that is, in the same color buckram with the same wording.  Sometimes two or more volumes may be bound together.  The call number is not imprinted on the spine in binding.  If one volume is smaller than the one and a half inches listed in the basic guidelines, it should still be commercially bound so that the set is uniform.  (We may or may not go back and bind volumes previously stiffened.)  The set cataloger has a supply of “piggyback” barcodes to place on the title pages of books to be commercially bound.  The volumes should be placed on the designated shelf in the Preservation Services area.

 

 

3.  BINDING GUIDELINES FOR SCORES

Scores that are stapled in a single fold can be pamphlet bound by sewing in In-house Binding.  They should be placed on the same shelf for In-house Binding, with regular barcodes clipped to the covers and a temporary location of “Inprocess.”  Scores thicker than ¼” should be sent to the commercial bindery (bound as music to lie flat, with a clear cover), not pamphlet bound.  If the score plus any parts is thicker than ¼”, it should be sent to the bindery.

Most scores are sent to the commercial bindery.  The Score Cataloger has a supply of “piggyback” barcodes to place on the title pages of scores to be commercially bound.  Such scores should be placed on the designated shelf in the Preservation Services area.  Scores in large sets are bound to match and have the call number imprinted on the spine by the bindery.