Section VIII, Chapter I
Binding Guidelines for Paperbacks and Scores
1. BINDING GUIDELINES FOR PAPERBACKS
1.1 General guidelines
Most paperbound books are sent to be shelved “as-is.” As with hardback books, barcodes are affixed to the inside back cover and the temporary location is “Inprocess” unless they are to be pam-bound (see below). These paperbound books may need binding in the future if they show wear and tear after circulation, but many of them will hold up well for many years with limited circulation.
1.2 Guidelines for commercial binding
...
Some paperback books should be sent to the commercial bindery. Guidelines for types of paperbacks to be commercially bound are as follows:
- Paperbacks over one and one-half inches thick
- Paperbacks that are under 1/4 inch thick
- Paperbacks that are stapled in the spine (i.e. similar to a musical score or newsletter)
- Very heavy paperbacks
- Art catalogs
- Very expensive paperbacks ($150 or more)
...
- Paperbacks that are in poor condition
- Paperbacks with uncut pages
- Paperbacks with obvious poor construction (e.g., covers loosely attached, pages not sewn in, etc.)
- Volumes of sets that should be bound to match (see below)
- Spiral-bound and comb-bound materials
- Paperbacks that have associated materials, e.g., CD-ROMs, maps, etc. already in
a pocket or needing a pocket
Rapidly superseded paperbacks. Computer manuals that are rapidly superseded are not commercially bound. Other titles that are rapidly superseded (e.g., annual or bi-annual editions) should not be commercially bound. For non-document materials, anything thinner than ¼” should be sent to In-House Binding for a pamphlet binding. Documents thinner than ¼” can be pamphlet bound on request. Barcodes should not be attached directly to the piece, but paper clipped to the piece. Piggyback barcodes may also be used.
Barcodes. Paperbacks to be commercially bound should have only automatic (Sirsi supplied) barcodes and should have a temporary location of “Inprocess.” Place them on the designated shelf in the Preservation Services area. Preservation Services personnel will place special “piggyback” barcodes in these volumes, overlay the automatic barcode, charge them out, and send them to the bindery. Do not put barcodes in any books going to the bindery unless you use “piggy-back” barcodes.
Rush books. Rush books that need to go to the commercial bindery should receive a regular barcode in the back, with a note penciled above to “send to Binding when discharged,” then given to the Marking Table.
Flags. Do not put any flags (Reference, Restricted, Cut pages, BIC, WRC) for items going to commercial binding. Do use “Notify” and “Book Plate” flags. Remember that if the record number is written too close to the bottom of the title page it may be trimmed off. Books needing “Tip-in” book plates can be sent to the bindery with a flag noting that it needs a “Tip-in.”
Questions. When in doubt, consult the Preservation Librarian
2. BINDING GUIDELINES FOR SETS
...
3. BINDING GUIDELINES FOR SCORES
Scores that are stapled in a single fold can be pamphlet bound by sewing in In-house Binding. They should be placed on the same shelf for In-house Binding, with regular barcodes clipped to the covers and a temporary location of “Inprocess.” Scores thicker than ¼” should be sent to the commercial bindery (bound as music to lie flat, with a clear cover), not pamphlet bound. If the score plus any parts is thicker than ¼”, it should be sent to the bindery.
Most scores are sent to the commercial bindery. The Score Cataloger has a supply of “piggyback” barcodes to place on the title pages of scores to be commercially bound. Such scores should be placed on the designated shelf in the Treservation Preservation Services area. Scores in large sets are bound to match and have the call number imprinted on the spine by the bindery.
Prepared by: Andy Damico and Keith Chapman
Last updated: July 26, 2007
Index terms: Binding paperbacks, commercial binding, rush books, sets, scores